Rotating Tree Shear
video
Rotating Tree Shear

Rotating Tree Shear

We build felling attachments for excavators, and the old clearing setup still shows up on too many sites: one machine to fell, another to cut stems to length, a third to stack the pile. Our Rotating Tree Shear collapses those three jobs into one attachment — shear, grip, section and stack — on the same carrier, without a second machine in the convoy.
Send Inquiry
Description

We build felling attachments for excavators, and the old clearing setup still shows up on too many sites: one machine to fell, another to cut stems to length, a third to stack the pile. Our Rotating Tree Shear collapses those three jobs into one attachment - shear, grip, section and stack - on the same carrier, without a second machine in the convoy.

 

Controlling where a tree leans is the difference between a clean day and a repair bill. The jaws grip the trunk before the cut, so the operator steers the fall - the wind does not decide, and no one walks under the leaning timber. That is the whole safety case: the felling cycle runs without a ground crew standing next to the trunk, and the direction of the fall is a choice, not a gamble.

 

Key Features

 

Three things the material list leaves out, and the crews care about.

Replaceable blades

Cutting edges swap individually when worn - the rest of the unit stays on the job, and spares cost less than a new attachment.

Optional rotation

Add the rotating structure for dense stands and slope cuts, where the held stem has to turn without the carrier shuffling.

One carrier, whole job

Felling, sectioning and stacking run on the same attachment - no procession of support equipment following the machine around the site.

 

Applications

The three sites below are where this Rotating Tree Shear changes the clearing math.

 
 

Dense and uneven woodland

Tight stands with little room to swing - the optional rotation turns the held stem instead of the carrier, so no repositioning burns the shift.

 
 
 

Inclined terrain

On banks and hillsides, the gripped stem is turned and laid before it can roll, so the pile stays exactly where the extraction crew reaches it.

 
 
 

Thinning and selective cuts

Section the stems as they fall and stack them by the row - the hauling crew picks them up without re-handling.

 

 

Technical Specifications

 

Every number that matters sits in the table below - carrier class, flow, pressure and cutting diameter - and this Rotating Tree Shear comes in four sizes, from mini excavators up to large carriers.

 

 

SL02

SL04

SL06

SL08

Excavator Class (t)

2–4.5

5–9.5

10–17

18–25

Flow Rate (L/min)

20–30

30–55

50–80

80–140

Working Pressure (Bar)

100–120

110–140

120–160

140–180

Cutting Diameter (mm)

100–150

150–200

200–250

250–300

 

Hot Tags: rotating tree shear, China rotating tree shear manufacturers, suppliers, factory, Hydraulic Tree Shear Grapple, rotating tree shear for excavator, tree shear attachment, tree shear for 13 ton excavator, vertical tree cutting shear, Vertical Tree Shear

Send Inquiry

(0/10)

clearall